HP 16500B User Manual
Page 21
5
Slide the interface module into the mainframe through the slot in the rear panel.
6
Install the screws connecting the interface module to the mainframe.
Two screws through the top of the interface module connect it to the sheetmetal plate, and
four screws through the rear plate of the interface module connect it to the rear panel of the
mainframe.
7
Connect the end of the 40-pin CRT cable to the interface module.
8
Connect the 80-pin cable to the CPU board and to the interface module.
a
Slide the 80-pin cable halfway through the rear slot of the card cage between the
interface module and the CPU board.
b
Connect the cable to the CPU board.
c
Connect the cable to the interface module.
9
Connect the 10-pin cable to the CPU board and to the interface module.
10
Replace the top and bottom covers, the optional modules, and the rear feet of the
mainframe.
11
Turn on the system.
a
Connect a power cord to the frame.
b
Turn on the line switch located on the rear panel the frame.
c
Turn on the power standby switch located on the front panel of the mainframe.
When the power-up tests are complete, the mainframe screen shows "Ethernet" in the
Communications menu.
Preparing for Use
To install the HP 16500L interface module
2–8