To remove and replace a simm memory – HP 16500B User Manual
Page 89
Advertising
To remove and replace a SIMM memory
HP 16500B
1
Using previous procedures, remove the following assemblies:
•
Microprocessor (CPU) board
2
Hold the release tabs away from the SIMM (single inline memory module), then pull
the module out.
3
Reverse this procedure to install the replacement SIMM.
Slide the SIMM module into the connector at an angle, then push it down parallel to the
microprocessor board.
Replacing Assemblies
To remove and replace a SIMM memory
6–14
Advertising