HONDA 2010 Fit - Manual (Page 98)

2. Separate the transmitter by prying
its middle seam with your
fingernail.
3. Inside the transmitter, separate the
inner cover from the keypad by
carefully prying on the edge with a
coin.
4. Remove the old battery, and insert
a new battery into the back of the
cover with the
＋ side facing down.
An improperly disposed of battery
can hurt the environment. Always
confirm local regulations for
battery disposal.
5. Install the parts in reverse order.
As required by the FCC: This device
complies with Part 15 of the FCC rules.
Operation is subject to the following two
conditions: (1) This device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210. Operation is
subject to the following two conditions:
(1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
BATTERY
Remote Transmitter
92