Hearth and Home Technologies GBST4336I - Manual (Page 37)

37 Heatilator • GBST4336I, GBFL4136I • 2135-900 Rev. D • 11/08
F. Install the Log Assembly
Log Set Assembly: LOGS-2129
Models: GDST4336I, GDFL4136I, GDCL4136I, GDCR4136I,
GBST4336I,
GBFL4136I
CAUTION! Logs are fragile! Carefully remove the logs and cardboard tray from the inside of the fi replace. See Figure
Remove the microfoam and inspect the logs for damage. Inspect the four factory installed logs for damage. Locate the
pilot in order to verify your position in relation to the appliance. See Figure 2.
LOG PLACEMENT
INSTRUCTIONS
Figure 2. Factory Installed Logs and Pilot Position
STEP 1. Log #1 (SRV2129-704): Place Log #1 on Log A. The end and bottom of Log #1 fi t into the indentation on
Log A highlighted in Figure 3. The Y-shaped end of Log #1 will rest on the smooth area of Log B as shown in Figure 4.
CAUTION: DO NOT reposition logs that have been
factory installed! Follow these instructions to position
the logs that were packaged separately.
Figure 4. Placement of Log #1
1 1
HUMP HUMP
C C
1 1 2 2 3 3
A A
B B
C C
D D
Figure 1. Log Assembly Location
Figure 3. Placement of Log #1
B B
A A
1 1
1 1
A A
PILOT PILOT
PILOT PILOT
PILOT PILOT
Models: GDST4336I, GDFL4136I, GDCL4136I, GBST4336I, GBFL4136I
(For Model GDCR4136I, see next page.)
Log Set Components
2129-935