Hearth and Home Technologies GBST4336I - Manual (Page 38)

Heatilator • GBST4336I, GBFL4136I • 2135-900 Rev. D • 11/08 38
STEP 2. Log #2 (SRV2129-705): Locate portion of Log #2 that is highlighted in Figure 5. Place that portion of Log
#2 on the indentation on Log C. Log #2 will rest on the tip of Log B. Slide the bottom of Log #2 up to the edge of the burner
as shown in Figure 6.
Figure 6. Placement of Log #2
2 2
STEP 3. Log #3 (SRV2129-707): Place Log #3 so that it rests on the indentations located on Log #2 and Log D.
Log 3 should extend beyond Log #2 by one inch.
Figure 8. Placement of Log #3
Figure 5. Placement of Log #2
Figure 7. Placement of Log #3
B B
C C
D D
B B
2 2
BURNER EDGE BURNER EDGE
1 in. 1 in.
2 2
PILOT PILOT PILOT PILOT
PILOT PILOT
PILOT PILOT
3 3
2 2
D D
Model: GDCR4136I
STEP 1. Log #1 (SRV2129-704): Place Log #1 on Log A. The end and bottom of Log #1 fi t into the indentation on
Log A highlighted in Figure 9. The Y-shaped end of Log #1 will rest on the smooth area of Log B as shown in Figure 10.
Figure 9. Placement of Log #1 Figure 10. Placement of Log #1
1 1
A A
1 1
A A B B
B B