Hawking Technology H2BR4 - Manual (Page 45)

Parameter
Description
Enable Port Forwarding
Enable Port Forwarding
Private IP
This is the private IP of the server behind the NAT firewall.
Note: You need to give your LAN PC clients a fixed/static IP address for
Port Forwarding to work properly.
ype This is the protocol type to be forwarded. You can choose to forward
“TCP” or “UDP” packets only or select “both” to forward both “TCP”
and “UDP” packets.
ort Range The range of ports to be forward to the private IP.
AN Port Assign the WAN port that requires port forwarding. All the packets sent
from this WAN port with the assigned port range will be directed to the
assigned private IP addresses.
omment The description of this setting.
dd Port Forwarding into the table Fill in the "Private IP", “Type”, “Port Range”, “WAN Port” and
"Comment" of the settings to be added and then click "Add". Then this
Port Forwarding setting will be added into the "Current Port Forwarding
Table" below. If you find any errors before adding it and want to type it
in again, just click "Clear" and the fields will be cleared.
emove Port Forwarding into the table If you want to remove some Port Forwarding settings from the " Current
Port Forwarding Table", select the Port Forwarding settings you want to
remove in the table and then click "Delete Selected". If you want to
remove all Port Forwarding settings from the table, just click the "Delete
All" button. Clicking "Reset" will clear your current selections.
T
P
W
C
A
R
Click Apply at the bottom of the screen to save the above configurations. You can now configure other advanced sections
or start using the router (with the advanced settings in place).
45