Hawking Technology H2BR4 - Manual (Page 66)

t using the ro
Description Parameters
Enable
DMZ Enables/disables DMZ.
ublic IP Address The IP address of the WAN port or any other Public IP addresses given to you by your
ic IP or static IP given by your ISP. If your ISP
gives you more than one dynamic IP address, you have to assign the session number that
you want to apply.
Client PC IP Address
Input the IP address of a particular host in your LAN that will receive all the packets
originally going to the WAN port/Public IP address above.
Note: You need to give your LAN PC clients a fixed/static IP address for the DMZ
function to work properly.
Add DMZ
Fill in the "WAN Port", "Public IP Address” and “Client IP Address” of the DMZ to be
added and then click "Add". This DMZ entry will then be added into the "DMZ Table"
below. If you find any errors before adding it and want to retype it again, just click
"Clear" and the fields will be cleared.
Remove DMZ
If you want to remove a DMZ from the "DMZ Table", select the DMZ entries you want to
remove in the table and then click "Delete Selected". If you want to remove all DMZ
entries from the table, just click the "Delete All" button. Clicking "Reset" will clear your
current selections.
Note: If there is a conflict between the Virtual Server and the DMZ setting, then the
Virtual Server function will have priority over the DMZ function.
WAN Port The WAN port that the local client PC’s IP address will bind to.
P
ISP. The WAN port may use dynam
You can now configure other advanced sections or star
uter (with the advanced settings in place).
66