Hawking Technology H2BR4 - Manual (Page 53)

Destination IP Range
Only packets with this assigned destination IP range will statically bind to the assigned
WAN port.
WAN port.
estination Port Range Only packets with this assigned destination port range will statically bind to the assigned
WAN port.
rotocol Only packets with this assigned protocol will statically bind to the assigned WAN port.
AN Port The WAN port that the packets matching this rule are statically bound to.
dd a Rule Fill in the "Source IP Range", "Destination IP Range”, “Source Port Range”, "Destination
Port Range", "Protocol" or "WAN Port" of the setting to be added and then click "Add".
This rule of Protocol and Port Binding will then be added into the "Protocol and Port
Binding Table" below. If you find any errors before adding it and want to retype it again,
just click "Clear" and the fields will be cleared.
emove a Rule If you want to remove a rule from the "Protocol and Port Binding Table", select the rules
you want to remove in the table and then click "Delete Selected". If you want to remove
all rules from the table, just click the "Delete All" button. Clicking "Reset" will clear your
current selections.
Source Port Range Only packets with this assigned source port range will statically bind to the assigned
D
P
W
A
R
Click Apply at the bottom of the screen to save the above configurations. You can now configure other advanced sections
r start using the router (with the advanced settings in place). o
53