Hearth and Home Technologies GBI25 User Manual

Page 2

Advertising
background image

26678 Rev H

2

02-02

GBI25 SERIES B-VENT GAS FIRED FIREPLACE INSERT

CAUTION:

Do not expose the appliance to the elements (such as rain, etc.)

SAFETY PRECAUTIONS

1. Please read these installation instructions completely

before beginning installation procedures. Failure to

follow them could cause a malfunction resulting in

serious injury and/or property damage.

2. Installation and repair should be done by a qualified

service person. This appliance should also be

inspected annually by a qualified service person. More

frequent inspections/cleaning may be required due

to excessive lint from carpeting, bedding material, etc.

It is imperative that the control compartment and

burners of the appliance be kept clean.

3. The GBi25is a vented gas appliance. Do not burn

wood or other material in this appliance.

4. NEVER leave children unattended when there is a

fire burning in the fireplace.

5. This appliance must be vented with a minimum 4” B-

Vent system and must terminate above the roof line.

Venting must not be connected to a chimney flue

servicing a solid fuel burning appliance.

6. Use only the fuel gas specified on the rating label of

this gas appliance.

7. The appliance area shall be kept clear and free from

combustible materials, gasoline and other flammable

vapors and liquids.

8. While servicing this appliance, always shut off all

electricity and gas to the appliance. This will prevent

possible electrical shock or burns. Also, make sure

the fireplace is completely cooled before servicing.

9. Do not use this appliance if any part has been under

water. Immediately call a qualified service technician

to inspect the appliance and to replace any part of the

control system and any gas control which has been

under water.

10. Be sure to provide adequate clearances around the

air openings into the combustion chamber and

adequate accessibility clearances for servicing and

proper operation.

11. Provisions shall be made to provide adequate

combustion and ventilation air. The flow of combustion

and ventilation air should not be obstructed.

Contents

A. Listings and Code Aprovals ..................................................................................................... 3

B. Description of the System ....................................................................................................... 3

C. System components ............................................................................................................... 4

D. Dimensions and Clearances ................................................................................................... 4

E. Pre-Installation Preparation ..................................................................................................... 5

F. Step-by-Step Installation of the System ...................................................................................6

G. Operating Instructions ........................................................................................................... 14

H. Maintenance Instructions ....................................................................................................... 16

I. Troubleshooting ..................................................................................................................... 17

J. Replacement Parts ............................................................................................................... 18

K. Optional Components ........................................................................................................... 19

Index ...................................................................................................................................... 23

Warranty ................................................................................................................................ 24

Advertising