Hearth and Home Technologies GBI25 - Manual (Page 9)

02-02 9 26678 Rev H
GBI25 SERIES B-VENT GAS FIRED FIREPLACE INSERT
7) DO NOT PACK INSULATION INSIDE THE
SURROUND.
8) Remove the switch from wire assembly and
feed wire through the brass trim. See
Figure 15. Re-install the switch to the wires
and push into place. See Figure 16.
WARNING!
ELECTRICAL GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong
(grounding) plug for your protection against shock
hazard and should be plugged directly into a prop-
erly grounded three-prong receptacle. Do not cut or
remove the grounding prong from this plug.
Figure 11 - Installation of Hood
Figure 12 - Assemble Brass Trim
Figure 13 - Installation of Surround Hood
Figure 14 - Installation of Surround Hood
Figure 15 - Installation of ON/OFF Switch
Figure 16 - ON/OFF Switch in Surround Installed
Important: Remove all shipping material, fingerprints
and smudges from the brass trim prior to burning the
appliance. If this is not done, they will be burned into
the trim.