Husqvarna 80792 - Manual (Page 11)

11
7 8
9 10
11 12
High Capacity
*2 required
PARTS LIST
1 Adapter Bolt
2 Outer Housing
3 Eyelets
4 Inner Spool
5 Retaining Ring
6 Outer Cover
7 Spring
Replace the cover. Tighten the lower
knob by turning counterclockwise.
Pull the line ends free from the line
saver slots.
Check for maximum line overlap of
one to two inches (four to five inches
of line extending from each eyelet). Trim as required to final length.
Thread the ends of the line into the
eyelets in the housing. Do not allow
line to go under the spool. Continue winding the line onto the
spool, keeping one finger between
the lines. Lock the ends of each line
segment into line saver slots in the
spool.
Replace the arbor bolt in the top of
the trimmer head. Install the spacers
as shown.
8 Spring Housing
9 Button/Knob
10 Retainer Bolt
11 Knob Tap
99909-007
Item Part No.
1 99909-217
2 101061
3* 106003
4 101030
5 103025
6 101053
7 107006
8 101054
9 101074
10 102082
11 101072
99909-008
Item Part No.
1 99909-218
2 101061
3* 106003
4 101030
5 103025
6 101053
7 107006
8 101054
9 101074
10 102082
11 101072
Line Saver
Slot
1" to 2"