Husqvarna 80792 - Manual (Page 8)

8
NOTE: Operating with trimmer line of
uneven length will cause excessive
vibration. Always make sure the line is
wound evenly and trimmed to equal
lengths from the eyelets.
INSTALLATION INSTRUCTIONS
E-Z Load and E-Z Pro Trimmer Heads
1 2 3
4 5 6
E-Z Load E-Z Pro
Line Chart
Press the upper body in at the spots
marked “Push Open”. Pull the lower
part of the trimmer head down. Remove the line spool from the lower
body of the trimmer. If nylon line is extending through the
eyelets, push the bump knob in while
rotating the line spool until the slots in
the spool line up with the eyelets, then
remove the spool.
Clean and inspect the spool, housing
and eyelets. Replace worn or dam-
aged components. Cut two equal lengths of trimmer line,
no longer than 25 feet each. Place an
end from each piece of line in the
holes in the center of the spool. While holding the line ends, pull each
line down toward the inside of the
spool through the slots next to the
holes.
E-Z Load
99909-017
Fits LT18, T18, LT20, T20, C20, T230,
C230, 22T
99909-018
Fits F20, T25, C25, T250, C250, T27,
C27, T270, C270, T260, C260, BP35
99909-018RB
Fits 22F E-Z Pro
99909-028
Fits T25, C25, T27, C27, T250, C250,
T270, C270
99909-020
Fits B40, B45, B450, C35, C350,
RC45
E-Z Load
99909-017
99909-018
Shipped with 15
feet of .095 line.
Maximum fill–
45 feet of .080
34 feet of .095
32 feet of .105
E-Z Pro
99909-028
99909-020
Shipped with 15 feet
of .095 line.
Maximum fill–
50 feet of .080
40 feet of .095
36 feet of .105