Husqvarna 80792 - Manual (Page 6)

6
NOTE: Operating with trimmer line of
uneven length will cause excessive
vibration. Always make sure the line is
wound evenly and trimmed to equal
lengths from the eyelets.
INSTALLATION INSTRUCTIONS
SemiMatic Trimmer Head
1 2 3
4 5 6
Model View
Line Chart
99909-15500
Fits LT18, T18, T20, C20, LT20, T230,
C230, 22T
99909-15600
Fits F20, T25, C25, T27, C27, BP35,
T250, C250, T260, C260
99909-15500
99909-15600
Shipped with 10 feet of .095 line
Maximum fill–
40 feet of .080
26 feet of .095
20 feet of .105
Turn the knob clockwise to remove
the knob and spool (one piece). Make
sure the white lock tab is visible in the
“L” window on the knob before starting
to turn. Remove the knob and spool. Clean the housing and spool and
inspect for damage and wear. If the
eyelets are worn excessively, replace
the housing. Note: The inner and
outer cams in the spool can be
serviced by a dealer.
Replace the line by threading it
through the eyelet in the spool until
the line ends are of equal length. With the knob facing away from you,
wind the line counterclockwise. Hook
the line into line saver slots in the
spool housing. Install the knob and spool in the
housing while threading the line
through the eyelets. Pull the line to
seat the spool.
Spool Saver
Slot