Husqvarna 80792 - Manual (Page 13)

13
7 8
9 10
11 12
PARTS LIST
To advance line: With the engine off, loosen the wing nut a few turns in the
direction of rotation. Grasp the trimmer head with both hands. Rotate the
bottom of the spool clockwise and pull the line through the eyelets. Re-tighten
the wing nut before operating the trimmer.
Use your finger to separate the line
end into two separate sections. Doing
so will assist in a smooth line feed
when the head is reassembled. Holding the spool and wound line in
one hand, place the line ends 180
degrees apart. Note: The photo
illustrates the spool for 72414-15100.
Hold the spool over the housing and
feed one line into an eyelet. As you
place the spool in the head, feed the
other line into the opposite eyelet.
Make sure one line does not slide
under the spool. Tip: Sometimes it’s easier to remove
one eyelet when installing the second
piece of line. Slide the eyelet over the
line for two to three inches, then push
the eyelet in place as the spool is
replaced in the housing.
Reinstall the spring and wing nut
knob. Tighten firmly. A properly reassembled head should
have four to five inches of line extend-
ing from each eyelet, and the overlap
should be one to two inches. Trim as
required to final length.
Midget Manual
Head
72414-15100
Item Part No.
1 72414-15110
2 72414-15120
3* 72005-92630
4 72414-15140
5 72005-92660
6 72414-15160
72086-15100
Item Part No.
1 72086-15110
2 72414-15120
3* 72005-92630
4 72414-15140
5 72005-92660
6 72031-15160
72031-15100
Item Part No.
1 72005-92710
2 72414-15120
3* 72005-92630
4 72414-15140
5 72005-92660
6 72031-15160
1
Adapter
Bolt
2
Outer
Housing
3
Eyelets
4
Inner
Spool
5
Spring
6
Knob
Midget Manual
High Profile
Head
72005-92600
Item Part No.
1 72005-92710
2 72005-92620
3* 72005-92630
4 72005-92640
5 72005-92660
6 72031-15160
99909-151
Item Part No.
1 72017-92710
2 72005-92620
3* 72005-92630
4 72005-92640
5 72005-92660
6 72031-15160
High Profile
*2 required
1" to 2"