Hotpoint EG1000GX - Manual (Page 24)

24
GB
Installation
CONVERSION FOR USE ON BUTANE
OR PROPANE
Each hob burner requires the injector to be replaced
and each burner gas tap to have the by-pass screw
adjusted according to the following procedure:
1. Lift off the burner cap and the burner body and
place it to one side.
2. Remove the injector from the burner base with a
suitable box spanner and discard.
3. Replace the injector with the appropriate
replacement (see Table on the previus page).
4. Repeat for each burner.
5. Replace the burner bodies and caps, taking care
that they are positioned correctly.
6. Remove the tap knob from the left hand hotplate
tap. Insert a narrow flat screwdriver centre of the
tap spindle and turn fully clockwise. Replace the
tap knob. Repeat this procedure with the other six
hotplate taps.
7. Position and fix the self-adhesive LPG conversion
label over the gas details on the rating plate label.
SPACE FOR FIXING
The cooker can be close fitted below hotplate level.
This requires a minimum distance of 1000mm
between cupboard units of hotplate height.
When installing next to a tall cupboard, partition or
wall, for a minimum distance of 400mm above
hotplate level, allow a side clearance of at least
65mm.
The diagram below illustrates the minimum
clearance between the cooker and adjacent walls,
cupboards etc.
The wall behind the cooker between the hotplate and
450mm above, and the width of the cooker, must be
a non-combustible material such as ceramic wall
tiles.
If the cooker is to be fitted close to a corner on the
left hand side, ensure that there is a clearance of at
least 50mm to allow the main oven door to open fully
for when removing oven shelves.
750mm min
COOKER HOODS
If a cooker hood is to be installed, refer to the
cooker hood manufacturers' instructions regarding
fixing height.
UNPACKING THE COOKER
Unpack the components from inside the grill and
oven. Check that the following parts are present:
Meat pan Pan supports
Grill pan, grid and handle LPG conversion kit
Hotplate burners parts Oven & Grill shelves
Griddle (EG1000GX only) Literature pack
After unpacking your cooker, make sure that you
remove all the packing from the oven and grill, and
any stickers from the oven door and the hob.
LEVELLING
Your cooker is heavy, so it would be advisable for
two people to move it. The cooker is fitted with rear
wheels and will slide into position easily. Movement
of your cooker is most easily achieved as follows.
Open the grill/oven door sufficiently to allow a
comfortable grip on the underside front edge of the
oven roof, avoiding any grill or oven interior furniture,
and then lift and slide back at the same time.
Your cooker must stand on a flat surface so that the
hob is perfectly level, and the cooker is stable and
cannot be rocked, this is easily achieved by
adjusting the three feet which are under the front of
the cooker and the 3 castors under the rear of the
cooker, if necessary.