Hotpoint EG1000GX - Manual (Page 25)

25
GB
Installation
STABILITY BRACKET
The cooker must be fitted with a stability device
firmly secured to the fabric of the building.
The M6 bolt at the top of the rear of the cooker can
be used to engage a stability chain. Keep the chain
clear of controls and pipes on the rear of the cooker.
The chain must be fitted to the wall behind the
cooker.
NOTE: If the cooker is to be placed on a base,
precautions must be taken to prevent it from
slipping off the base.
The cooker is designed to match the depth of
standard 600mm worktops.
An adaptor backplate should, therefore, be fitted
within the shaded area shown to allow the cooker to
be pushed fully to the wall. If a forward facing
backplate is used, it must be chased into the wall.
180
370
450
250
750 750
Connection to the cooker should be made with an
approved appliance flexible connection to BS 669. A
length of 0.9 to 1.25m is recommended. The length
of hose chosen should be such that when the cooker
is in situ, the hose does not touch the floor.
The temperature rise of areas at the rear of the
cooker that are likely to come in contact with the
flexible hose do not exceed 70°C.
LPG cookers should be connected with a hose
suitable for LPG and capable of withstanding
50mbar pressure.