Electrical connection – Hotpoint EG1000GX User Manual

Page 26

Advertising
background image

26

GB

Electrical Connection

WARNING - THIS APPLIANCE MUST BE

EARTHED

Your cooker should have been checked to ensure

that the voltage corresponds with your supply

voltage, which is stated on the data badge fitted on

the rear panel.

The cooker must be connected by a contractor/

engineer who is registered with the National

Inspection Council for Electrical Installation

Contracting (NICEIC), to a suitable double - pole

control unit with a minimum rating of 30A and a

minimum contact clearance of 3mm, which should

be fitted adjacent to (but not above) the cooker, in

accordance with IEE regulations.

The power supply cable should conform to BS6004

with a conductor size of 4mm

2

.

The power supply cable must be type H05RR-F.

The control unit should be easily accessible in the

event of an emergency.

This appliance conforms to EN55014 regarding

suppression of radio and television interference.

Access to the mains terminals is gained by

removing the rear access cover.

The mains cable must pass through the cable clamp

adjacent to the terminal block.

Sufficient cable should be used to allow the cooker

to be pulled out for servicing.

INSTALLATION & OPERATIONAL

CHECKS

After installation, check for gas soundness.

Fit the hotplate burner bodies, burner port rings,

enamelled discs and pan supports referring to the

instructions for use where necessary.

1. Check that the hotplate burners ignite correctly and

burn with a steady flame.

Check for a steady flame on the low setting.

2. Check that with the left hand oven set at 230°C,

the oven fan operates and the oven heats up.

3. Check that with the right hand oven set at 230°C,

the oven heats up.

4. Check that the twin grill heats up.

5. Check that the warming drawer heats up.

6. Check operation of clock.

7. Check operation of the ceramic plate (model

EG1000EX only).

Instruct the user on the operation of the cooker.

Advertising