Hitachi CP-X10000 - Manual (Page 18)

18
Remote control
Using as a wired remote control
The accessory remote control works as a wired remote control,
when the wired control port at the bottom of the remote control
connects with the REMOTE CONTROL port on the back of the
projector via an audio cable with 3.5 diameter stereo mini plugs.
This function is useful when a wireless remote signal
may not reliably reach the projector.
• To connect the remote control with the projector, use an audio cable
with 3.5 diameter stereo mini plugs.
NOTE
I O
HDMI DVI-D
CONTROL IN CONTROL OUT REMOTE CONTROL
IN
OUT
S-VIDEO
COMPUTER IN2 COMPUTER IN1
VIDEO 1 BNC
R/Cr/Pr G/Y B/Cb/Pb H V VIDEO 2
Y
Cb/Pb
Cr/Pr
AC IN
LAN
MONITOR OUT
BLANK
LASER
FREEZ E
LASER INDIC ATOR
DIGITAL
STAN DBY/O N
COMP UTER
LENS S HIFT
KEYST ONE
ID 3
ID 4
ID 2
ID 1
VIDEO
AUTO
ASPEC T
RESET
MENU
MAGN IFY ON
OFF
3
4
ENTER
FOCU S +
-
POSITION
PbyP
ZOOM
+
-
1
2
MY BUTTON
MY SO URCE
SHUTT ER
Laser pointer
This remote control has a laser pointer in place of a finger or rod. The laser beam
works and the LASER INDICATOR lights while the LASER button is pressed.
Laser aperture
Using the REMOTE ID function
This is the function to define which projector is controlled by the remote control. Utilize
this function when you use some projectors of the same type at the same time.
1. Set the ID number to the projector beforehand,
referring to the item “REMOTE ID” item (
52).
2. Press a ID button on the remote control. The ID button
selected will light for 3 seconds.
• Each time you press any button (except ID buttons), the ID button of
current selected ID number will light.
• To confirm the projector's current ID, press any ID button for 3 seconds. Its
number will be shown on each screen regardless of set ID of projector.
NOTE
BLANK LASER
FREEZE
LASER
INDICATOR
DIGITAL
STANDBY/ON COMPUTER
LENS SHIFT
KEYSTONE
ID 3
ID 4 ID 2
ID 1
VIDEO
AUTO
ASPECT RESET
MENU
MAGNIFY
ON
OFF
3
4
ENTER
FOCUS
+
-
POSITION PbyP
ZOOM
+
-
1
2
MY BUTTON
MY SOURCE
SHUTTER
or
[Class 2 Laser product] Wave length: 650nm,
Maximum output: 1mW, No beam divergence
[Laser Diode]
Wave length: 650nm, Maximum power:
6mW, Beam divergence: 30deg (perpendicular)
/8deg (parallel)
IEC60825-1 : 1993 IEC60825-1 :2007
+A1 :1997 EN60825-1 :2007
+A2 :2001
WARNING ►Use the laser beam of the remote control only for the pointer
on the screen. Never hit eyes by the laser beam since the laser beam can
injure eyes. Do not apply the laser beam to anything except the screen.
CAUTION ►Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation exposure.