Hitachi CP-X10000 - Manual (Page 61)

61
SECURITY menu
This projector is equipped with security functions.
From the SECURITY menu, items shown in the table below can
be performed.
To use SECURITY menu: User registration is required before
using the security functions.
Enter the SECURITY menu
1. Use the ▲/▼ buttons on the SECURITY menu to select ENTER PASSWORD and press the ►
button. The ENTER PASSWORD box will be displayed.
If you have forgotten your password
1. While the ENTER PASSWORD box is displayed, press and hold the RESET button on the remote
control for about 3 seconds or press and hold the COMPUTER button for 3 seconds while pressing
the ► button on the projector.
2. The 10 digit Inquiring Code will be displayed. Contact your dealer with the 10 digit Inquiring Code.
Your password will be sent after your user registration information is confirmed.
• If there is no key input for about 55 seconds while the Inquiring Code is displayed, the menu will
close. If necessary, repeat the process from 1.
2. Use the ▲/▼/◄/► buttons to enter the registered password.
The factory default password is 9630. This password can be
changed (  SECURITY PASSWORD CHANGE). Move the
cursor to the right side of the ENTER PASSWORD box and
press the ► button to display the SECURITY menu.
• It is strongly recommended the factory default password to be changed
as soon as possible.
• If an incorrect password is input, the ENTER PASSWORD box will
be displayed again. If incorrect password is input 3 times, the projector
will turn off. Afterwards the projector will turn off every time an incorrect
password is input.
3. Items shown in the table below can be performed.
Item Description
SECURITY
PASSWORD
CHANGE
1 Use the ▲/▼ buttons on the SECURITY menu
to select SECURITY PASSWORD CHANGE
and press the ► button to display the ENTER
NEW PASSWORD box.
2 Use the ▲/▼/◄/► buttons to enter the new
password.
3 Move the cursor to the right side of the ENTER
NEW PASSWORD box and press the ► button
to display the NEW PASSWORD AGAIN box,
enter the same password again.
4 Move the cursor to the right side of the NEW
PASSWORD AGAIN box and press the ►
button and the NOTE NEW PASSWORD box
will be displayed for about 20 seconds, please
make note of the password during this time.
• Pressing the ENTER button on the remote control or ► button on the
projector will close the NOTE NEW PASSWORD box.
• Please do not forget your password.
SECURITY menu
(continued on next page)