HP 5400ZL - Manual (Page 399)

QinQ (Provider Bridging)
Event Log Messages and SNMP Support
Event Log Messages and SNMP Support
Table 8-3 shows the event log messages that may be generated when QinQ is
enabled on the switch.
Table 8-3. QinQ Event Log Messages
Message Meaning
system: Rebooting for qinq System reboot occasioned by a change in QinQ
mode change configuration mode.
QinQ: qinq mode - mixedvlan The device is configured to operate in qinq
mixed vlan mode.
QinQ: qinq mode - svlan The device is configured to operate in qinq svlan
mode.
SNMP Support and MIB Objects
The switch SNMP agent can make use of certain variables that are included
in a Hewlett-Packard proprietary MIB (Management Information Base) file.
Table 8-4 on page 8-34 shows the MIB objects that can be used to configure
the Q-in-Q (provider bridge) mode, the provider bridge port-type, and the QinQ
outer tag ethertype.
The MIB objects listed in the following table may be subject to change. The
walkmib <OBJECT-STR> CLI command can be used to verify the availability of
the listed MIB objects on the device.
To download the latest version of the MIB file:
1. Go to the ProCurve Networking Web site at: www.procurve.com
2. Click on software updates, then MIBs.
8-33