HP 5400ZL User Manual

Page 167

Advertising
background image

Multiple Instance Spanning-Tree Operation

Configuring MSTP

Syntax: [no] spanning-tree pending < apply | config-name | config-revision |

instance | reset >

This command exchanges the currently active MSTP
configuration with the current pending MSTP configuration.
Options are as follows:

apply: Exchanges the currently active MSTP configuration
with the pending MSTP configuration.
config-name: Specifies the pending MST region name. Must be
the same for all MSTP switches in the region.
(Default: The switch’s MAC address.)
config-revision: Specifies the pending MST region
configuration revision number. Must be the same for all MSTP
switches in the region.
(Default: 0).
instance < 1..16 > vlan < vid | vid-range >: Creates the pending
instance and assigns one or more VLANs to the instance.
reset: Copies the switch’s currently active MSTP configuration
to the pending configuration. This is useful when you want to
experiment with the current MSTP configuration while
maintaining an unchanged version.

To Create a Pending MSTP Configuration.

This procedure creates a

pending MSTP configuration and exchanges it with the active MSTP configu­
ration:

1. Configure the VLANs you want included in any instances in the new

region. When you execute the

pending command, all VLANs configured on

the switch will be assigned to a single pending IST instance unless
assigned to other, pending MST instances.(The

pending command creates

the region’s IST instance automatically.)

2. Configure MSTP as the spanning-tree protocol, then execute

write mem

and reboot. (The pending option is available only with MSTP enabled.)

3. Configure the pending region

config-name to assign to the switch.

4. Configure the pending

config-revision number for the region name.

5. If you want an MST instance other than the IST instance, configure the

instance number and assign the appropriate VLANs (VIDs) using the
pending instance < 1..16 > vlan < vid | vid-range > command.

6. Repeat step 5 for each additional MST instance you want to configure.

4-45

Advertising
This manual is related to the following products: