HP 5400ZL - Manual (Page 65)

Static Virtual LANs (VLANs)
Configuring VLANs
Descriptions of items displayed by the command are provided
below.
Port name: The user-specified port name, if one has been
assigned.
VLAN ID: The VLAN identification number, or VID.
Name: The default or specified name assigned to the VLAN. For
a static VLAN, the default name consists of
VLAN-x where “x”
matches the VID assigned to that VLAN. For a dynamic VLAN,
the name consists of
GVRP_x where “x” matches the applicable
VID.
Status:
Port-Based: Port-Based, static VLAN
Protocol: Protocol-Based, static VLAN
Dynamic: Port-Based, temporary VLAN learned through
GVRP.
Voice: Indicates whether a (port-based) VLAN is configured as
a voice VLAN.
Jumbo: Indicates whether a VLAN is configured for Jumbo
packets. For more on jumbos, refer to the chapter titled “Port
Traffic Controls” in the
Management and Configuration Guide
for your switch.
Mode: Indicates whether a VLAN is tagged or untagged.
Figure 2-20 is an example of the output when the detail option is not used.
ProCurve(config)# show vlan ports a1-a24
Status and Counters - VLAN Information - for ports A1-A24
VLAN ID Name | Status Voice Jumbo
------- -------------------- + ---------- ----- -----
1 DEFAULT_VLAN | Port-based No No
10 VLAN_10 | Port-based Yes No
15 VLAN_15 | Protocol No No
Figure 2-20. Example of “Show VLAN Ports” Cumulative Listing
2-33