Hearth and Home Technologies 6000TRS-CE - Manual (Page 33)

33
Figure 31. Sealant Material
Installing the Trim
Combustible materials may be brought up to the specified clearances on the side
and top front edges of the fireplace, but MUST NEVER overlap onto the front face.
The joints between the finished wall, fireplace top and sides can only be sealed with
a 150
° C minimum sealant.
Install optional marble and brass trim surround kits as desired. Marble, brass, brick,
tile, or other noncombustible materials can be used to cover up the gap between
the sheet rock and the fire-
place.
Do not obstruct or modify the
air inlet/outlet grilles. When
overlapping on both sides,
leave enough space so that
the bottom grille can be
opened and the trim door re-
moved.
Step 10 Installing Trim, Refractory, Logs, and Ember Material
1. Apply only non-
combustible
facing material
to the fireplace
surround.
CAUTION IF JOINTS BETWEEN THE FINISHED WALLS AND
THE FIREPLACE SURROUND (TOP AND SIDES) ARE
SEALED, A 150°
C. MINIMUM SEALANT MATERIAL
MUST BE USED. THESE JOINTS ARE NOT RE-
QUIRED TO BE SEALED. ONLY NONCOMBUSTIBLE
MATERIAL (USING 150° C. MINIMUM ADHESIVE, IF
NEEDED) CAN BE APPLIED AS FACING TO THE
FIREPLACE SURROUND. SEE FIGURE 31.
Installing the Ceramic
Refractory
Remove dress guard, glass
door and log package. Re-
move refractory pieces from
packaging (see Figure 32).
Position rear refractory piece
first and then slide both side
pieces through the upper
guide openings until they sit
firmly against the rear of the
unit. See following pages for
log installation instruction.
!
WARNING: CHILDREN AND ADULTS
SHOULD BE ALERTED TO THE HAZARDS
OF HIGH TEMPERATURES OF WORKING SUR-
FACES ON THESE HEATERS. WORKING SUR-
FACES INCLUDE ALL GLASS PANELS AND DEC-
ORATIVE DOORS. YOUNG CHILDREN SHOULD
BE CAREFULLY SUPERVISED WHEN THEY ARE
IN THE SAME ROOM AS THE APPLIANCE.
Figure 32. Holding Tabs
REAR
TABS
TOP SEAL
JOINT
SIDE SEAL
JOINT
1/2”
(.27 cm)
FINISH MATERIAL
MAY BE COMBUSTIBLE
- TOP AND SIDES
OF UNIT
1/2”
(.27 cm)