Husqvarna 210 C - Manual (Page 16)

English - 17
3. INSTALLATION
3.1 Preparations
1. If the lawn in the proposed working area is taller
than 4", mow it using a normal lawn mower. Then
collect the clippings.
2. Read carefully through all the steps before the
installation.
3. Check that all parts for the installation are
included:
The numbers in brackets refer to the detail
diagram 2.1 Automower™, what’s what? on
page 11.
• Operator’s Manual (23)
• Automower
• Loop generator/charger (18)
• Loop wire for the boundary wire (15)
• Staples (19)
• Connector for the loop wire (20)
• Measurement gauge (21)
• Solderless coupler for the loop wire (22)
During installation you will also need: A hammer to
knock the staples into the ground, combination pliers,
and a straight spade if the boundary wire is to be
buried.
3.2 Installation of the loop
generator/charger
The loop generator/charger must be placed where it
is well ventilated and is not exposed to direct sunlight.
The mower's battery is spared if it is charged in the
lowest possible ambient temperature. It is also
beneficial if the transformer can be placed under a
roof.
IMPORTANT INFORMATION
The power cord for the loop
generator/charger must not be replaced. If
the power cord is damaged the loop
generator/charger must be scrapped and
replaced with a new unit.
3012-756
3012-757