Husqvarna 210 C - Manual (Page 17)

18 - English
3. INSTALLATION
Consider the distance to a wall socket when choosing
the position. The loop generator/charger must be
connected to a 120 V wall socket and there must be
room for the mower when it is to charged.
It is recommended to use an earth fault-breaker when
connecting the transformer to the wall socket.
Tip! If, for reasons of space or for some other reason,
it is not suitable to charge the mower where the loop
generator/charger is positioned, a freestanding
charger can also be used. A charger can be
purchased as an accessory. Contact your dealer for
further information.
Installation and connecting the loop
generator/charger
1. Position the loop generator/charger in a suitable spot.
2. Connect the loop generator/charger's power cord
to a 120 V wall socket. It is preferable to use an
earth-fault breaker as recommended.
3.3 Charging the battery
Automower is supplied with an uncharged battery. As
soon as the loop generator/charger is connected, it is
possible to charge the mower.
1. Set the main switch to the ON position and leave
the cover for the control panel open.
2. Connect the charger cable from the loop
generator/charger to the charger contact on the
mower. The green indictator lamp Battery now
goes on. When the mower is fully charged the
green indicator lamp goes off, and the yellow
lamp starts flashing.
From an uncharged state the battery takes about
12 - 15 hours until it is fully charged.
Tip! Leave the mower connected to the charger cable
when not in use. As long as the mower is connected it
will be maintenance charged, which means the
battery will be fully charged when the mower is used.
This does not apply to winter storage, see 7.2 Winter
storage on page 38.
3012-752
3012-784
3012-758