Husqvarna 210 C - Manual (Page 43)

44 - English
8. TROUBLE SHOOTING
4 Outside
working area The boundary wire is
crossed when
connecting to the loop
generator/charger. Switch the two connections for the
loop generator/charger on the
boundary wire.
The gradient for the
boundary cable is too
steep. Check that the boundary wire has
been routed correctly.
The boundary wire has
been routed the wrong
way around an “island”. Check that the boundary wire has
been routed in accordance with the
installation instructions.
The boundary wire is
too close to the edge of
the working area. Check that the boundary wire has
been routed correctly.
If this occurs in isolated
areas it may be due to
interference from
metallic objects
(perimeter fence,
reinforcement bar) or
buried cables in the
vicinity. Try moving the boundary wire.
5 Wheel motor
blocked Grass or other object
has wrapped around the
drive wheel. Check the drive wheel and remove
the grass or other object.
5 Blade disc
blocked Grass or other object
has wrapped around the
blade disc. Check the blade disc and remove
the grass or other object.
Flashes Fault message Cause Action