Husqvarna 210 C - Manual (Page 41)

42 - English
8. TROUBLE SHOOTING
8. Trouble shooting
8.1 Fault messages
A number of fault messages that can be shown by the red Fault indicator lamp on Husqvarna
Automower™ are shown below. The fault message is interpreted by reading how the lamp flashes. The
lamp flashes one to five times in quick succession and then goes out for 2 seconds. This sequence is
repeated until the Cancel button is pressed. For example, three flashes in the table below corresponds to
the lamp flashing three times in quick succession, and then going out.
Always try to restart the mower if the Fault indicator lamp is lit or flashes. Restart the mower by pressing
the Cancel button, enter your PIN code and close the cover.
If the same fault occurs frequently, or if the Fault indicator lamp is lit with a steady light: contact your dealer.
Flashes Fault message Cause Action
1 Wrong PIN
code Wrong PIN code has
been entered. Three
attempts are permitted,
the keypad is then
blocked for five minutes. Enter the correct PIN code.
1 Charger cable
not connected The charger cable is not
connected when
changing the PIN code,
or when connecting the
mower to the loop
generator/charger. Connect the charger cable