Husqvarna 210 C - Manual (Page 28)

English - 29
4. USE
4.3 Restart
To start:
1. Enter the PIN code.
2. Press the YES button.
3. Close the control panel cover.
4.4 Switching off Automower™
1. Press the STOP button.
2. Set the main switch to the OFF position.
Always switch off Automower using the main switch if
you intend to perform maintenance or move the
mower outside of the working area.
4.5 Using the Timer
The lawn should not be mown for too long to obtain
the best result. Use the timer function to avoid
flattening the lawn and to get the maximum service life
for your Automower.
The timer function allows the user to select whether
the mower is to mow for 1, 2, 3 or the maximum
number of hours. The timer is especially useful for
mowing small areas, because it will not then be
necessary for the Automower to use its full capacity.
To set the Timer:
1. Enter the PIN code, and confirm with the YES
button.
2. Press and hold the number 1, 2 or 3 for two
seconds, depending on whether you want the
Automower to mow for one, two or three hours.
3. A double beep confirms your selection and the
indicator lamp for the PIN code goes off. It stays
off until you release the key (number).
4. Close the cover within 20 seconds, otherwise the
selected Timer settings will not be stored. The
timer is also reset every time the STOP button is
pressed
3012-774
3012-747
3012-846