Hearth and Home Technologies Hudson Bay Direct Vent Gas Appliance HUDBAY-FS - Manual (Page 28)

Page 28 10/08 Quadra-Fire • Hudson Bay • 7003-121 Rev. i
8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Accessories
Install approved accessories per instructions included with
accessories. Refer to Section 12 for appropriate accesso-
ries.
Shock or fi re risk.
Use ONLY optional accessories approved for
this appliance.
• U s i n g n o n - l i s t e d a c c e s s o r i e s v o i d s
warranty.
• Using non-listed accessories may result in a
safety hazard.
• Only Hearth & Home Technologies approved
accessories may be used safely.
WARNING
C. Door Crown Installation
Use a soft cloth and a window cleaning solution to clean
all fingerprint oils from the gold or nickel surface of crown
PRIOR to lighting the appliance.
Figure 8.1 Open lower access panel. Pull out and unhook
the two spring latches on the bottom of the appliance that
secure the door.
Rotate the door forward approximately 1-1/2 in. (38mm).
Holding the ashlip, lift the door up off of the stationary latches
and away from the appliance.
Stationary latches
Spring latches
Figure 8.2 Uninstall the existing crown by removing the four
screws on the back side of the door. Retain the screws.
Figure 8.3 Use a fl at-head screwdriver to pry the black crown
free on the right side. Remove the crown and discard.
Figure 8.4 Carefully align the left side of the crown into place,
and wrap it across the face of door, fi nally snapping it into
place on the right hand side. Reinsert and tighten the screws
previously removed.