Hearth and Home Technologies CFX-Crescent - Manual (Page 23)

Heat & Glo • CFX-CRESCENT • 705-900 Rev. P • 12/07 23
Figure 17. Trapezoid Termination Cap
For trapezoidal termination:
1. Screw the cap to the
exterior wall through
the flanges in the cap.
2. Seal the joint between
the pipe and the
exterior firestop.
!
WARNING: VENTING TERMINALS SHALL
NOT BE RECESSED INTO A WALL OR SID-
ING. VENT TERMINATION CLEARANCES
MUST BE FOLLOWED TO AVOID FIRE DANGER.
SEE VENT TERMINATION MINIMUM CLEARANC-
ES DIAGRAM ON FOLLOWING PAGE.
NOTE: For vinyl siding use protector kit VPK-Infinity.
Note: You must install the heat
shield while installing the top two
screws in the firestop.
HEAT
SHIELD
6-3/4”
(171m m )