HP 3100C - Manual (Page 50)

Backing up and restoring the digital sender 49
Backing up and restoring the digital sender
The Backup and Restore utilities save and recover the configuration
of all personal and public address books, and the configuration of the
digital sender. These utilities are stored in the \Utility folder on the
product CD and must be installed on a computer on the same
network as the digital sender.
To install the Backup and Restore utilities
1 On the product CD, browse to the Utilities folder.
2 Review the Readme.txt file
3 Run Install.bat. The utilities are installed to C:\HP 8100C\Utility.
Note Backup and Restore are command line programs which can be run
from a .bat or .cmd file.
Backing up the digital sender
Use this procedure:
● After configuring the digital sender, creating users, and
configuring public and personal address books
● Periodically to ensure recoverability of the digital sender to a
desired state
● Before performing firmware upgrades
Backup saves the configuration of the digital sender to a .tgz file on
your hard drive.
To back up the digital sender
1 Make sure the computer you are using has the Backup and
Restore utilities installed.
2 At a command line, run Backup using the following syntax:
backup.exe/dir: Backup Directory /d: Digital Sender
/p: Administrator Password /l/tr
Note Example: backup.exe /dir:c:\data /d:xxx.xxx.xxx.xxx /p:password /l /tr