HP 2500C Series - Manual (Page 173)

Removal and Replacement of Parts (without Calibration) 7-23
Replacement of Parts
Installing the MIDS
Step 1. Attach the retainer clip to the tubes and to fasten them in place to the chassis with the screw.
Step 2. Fasten the screw between “C” and “M”.
Step 3. Replace the pump section, tilting it an angle such that the catch next to the yellow nozzle is latched
first, and replace the screws.
Step 4. Replace the remaining components for the MIDS (refer to Steps 3-14 of Installing the Power Knob
from Replacement of Power Knob.)