Hayter Mowers Condor hydrostatic Drive 510D - Manual (Page 31)

1.31 1.31 MAINTENANCE
Running In Period - At First 50 Hours of
Use continued
Check belt tension - Cutterhead input drive:
Check the free play at the centre of the drive belt
span as shown using finger pressure. If adjustment
is required, refer to MOUNTING OF CUTTER-
HEAD ATTACHMENT.
Check belt tension - Main engine drive: Check
the free play at the centre of the drive belt as shown
using finger pressure. If adjustment is required
adjust the jockey pulley bracket until the correct
belt tension is obtained.
Daily and Before Use
Check engine oil: If the oil level is below the
upper mark on the dipstick, top up with the correct
grade of engine oil, refer to ENGINE OWNER’S
MANUAL.
Air cleaner (Dual element type): Check the air
cleaner elements for holes or tears and replace if
damaged. Clean the paper element.
CAUTION: PREVENT DAMAGE - Always
replace a damaged air cleaner or damage to the
engine will result. NEVER run the engine with-
out the air cleaner correctly fitted.
Check fuel level: Top up as necessary with
unleaded petrol. Always top up before storing the
mower over night to prevent water condensation
from contaminating the fuel.
WARNING: PREVENT ACCIDENTS - Never
use petrol or low flash point solvents when
cleaning the air cleaner elements. A fire or
explosion could result.
WARNING: PREVENT ACCIDENTS - Petrol
is highly flammable. Observe all relevant safety
precautions. Refer to SAFETY PRECAUTIONS
- PREPARATION.
.....................
........
13mm
1 2
1. Drive Pulley Attachment (Cutterhead)
2. Countershaft Pulley (Power unit)
1
2
3
1. Drive Pulley Attachment (Cutterhead)
2. Countershaft Pulley (Power unit)