Hayter Mowers Condor hydrostatic Drive 510D - Manual (Page 43)

1.43 1.43 PREPARING THE MOWER FOR STORAGE
Preparing the Mower for storage
Storage for long periods: To ensure that the mower is
maintained in good working order it is important that
the following procedure is adopted when the mower is
stored for periods in excess of one month. Refer to the
maintenance section and engine handbook as neces-
sary.
WARNING: PREVENT ACCIDENTS - Ensure
that the mower is outdoors, away from all possible
sources of ignition and that the engine is cool prior
to carrying out the following procedure.
Drain fuel from the engine and carburettor.
Disconnect the spark plug lead. Change the engine oil.
Remove the engine spark plug and pour a tablespoon
of clean engine oil into the spark plug aperture. Do not
exceed the stated volume of oil as engine damage may
occur on restarting. Operate the engine start grip sev-
eral times to crank the engine. This will distribute the
oil. Replace the spark plug.
Pull the engine start - grip slowly until resistance is
felt. Continue pulling until the notch on the starter pul-
ley aligns with the hole on the recoil starter as shown
in the engine Owner’s Manual. At this point, the intake
and the exhaust valves are closed and this will help to
protect the engine from internal corrosion.
Clean all areas of the power unit, engine and cutter-
head attachment.
Lubricate the mower.
Treat bare metal parts with a water repellent anti-
corrosion product.
Rest the machine on wooden blocks to remove the
weight of the mower from its wheels.
Cover the mower with a protective sheet and store it in
a dry, ventilated area.