HP 16V - Manual (Page 66)

Menu Items
Config menu
Personality
Auto continue
I/O timeout
I/O buffers
Power save
On after I5 min
On after 30 min
On after 60 min
On after 120 min
O f f
Parallel menu
Acknowledge
Model
Mode2
Mode3
Bi-direction
NPAP mode
Serial menu
Baud rate
Pacing
DTR polarity
ROBUST XON
Selecting an emulation (personality) without a
PJL command which clearly specifies the
emulation
Automatic control of continuing recoverable
errors
Time interval allowed for switching the
interface
Size of interface buffer
Setting the time interval during which the
printer remains idle state before entering sleep
mode after printing last
Power save mode on. The printer enters sleep
mode after remaining idle state for ## minutes
after printing last.
Power save mode off. (Even in this mode, the
printer enters sleep mode after remaining idle
state for 180 minutes.)
The pulse width of the ACK signal
0.5 µs
1.0 µs
4.0 µs
Bi-directional Centronics interface mode
Whether the NPAP commands are used.
When using MarkVision™ , the NPAP mode
must be Auto or On.
Data transfer speed on the serial interface
Protocol of the serial interface
Level of the DTR signal in the DTR protocol
ROBUST mode in the Xon/Xoff protocol
User’s Manual 2-19