HP 16V - Manual (Page 84)

Installing an Alternate Emulation
Notice:
Do not touch any connector contacts to avoid possible electrostatic
damage to the printer.
3. Install the RAM card.
Push its top edge
downwards so that holes of
the card align with locating
pins of the connector and
the card is secured by
retaining chps.
Important:
When installing two RAM cards, first install the lower one, and then
the upper one.
Turn power on. If necessary, change buffer memory assignment
(page protect or jam recovery) using the control panel.
To remove an unsealed
RAM card push out the
retaining clips. When, the
card slants outwards pull
the card to remove.
Installing an
Alternate
Emulation
Alternate emulations are offered with emulation cards. You can use
these emulations to connect your printer to different computers. The
FPS emulation (PostScript Level 2 compatible) is available. It is
standard for the PrintPartner 16ADV but optional for the
PrintPartner 16DV.
The installation procedure is the same as that for the RAM card
except that the FPS emulation card uses the bottom connector.
User’s Manual 3-3