HP 48gII - Manual (Page 735)

Page 22-19
Example 3 – A polar plot. Enter the following program:
«
Start program
RAD {PPAR EQ} PURGE
Change to radians, purge vars.
‘1+SIN(
θ)’ STEQ Store ‘f( θ)’ into EQ
{
θ 0. 6.29} INDEP Set indep. variable to ‘ θ’, with
range
‘Y’ DEPND Set dependent variable to ‘Y’
POLAR Select POLAR as the plot type
{ (0.,0.) {.5 .5}
“x” “y”} AXES
Set axes information
–3. 3. XRNG
Set x range
–.5 2.5 YRNG
Set y range
ERASE DRAW DRAX LABEL
Erase & draw plot, axes, and labels
PICTURE
Recall graphics screen to stack
» End program
Store the program in variable PLOT3. To run it, press
J, if needed, then
press @PLOT3.
These exercises illustrate the use of PLOT commands in programs. They just
scratch the surface of programming applications of plots. I invite the reader to
try their own exercises on programming plots.
Drawing commands for use in programming
You can draw figures in the graphics window directly from a program by
using commands such as those contained in the PICT menu, accessible by
„°L@PICT@. The functions available in this menu are the following.
Press
L to move to next menu:
Obviously, the commands LINE, TLINE, and BOX, perform the same
operations as their interactive counterpart, given the appropriate input.
These and the other functions in the PICT menu refer to the graphics windows
whose x- and y-ranges are determined in the variable PPAR, as demonstrated
above for different graph types. The functions in the PICT command are
described next: