Library numbers, Deleting a library, Creating libraries – HP 48gII User Manual
Page 776: Backup battery
Page 26-7
Library numbers
If you use the LIB menu (
‚á) and press the soft menu key corresponding
to port 0, you will see library numbers listed in the soft menu key labels. Each
library has a four-digit number associated with it. These numbers are
assigned by the library creator, and are used for deleting a library.
Deleting a library
To delete a library from a port, use:
• In algebraic mode: PURGE(:port_number: lib_number)
• In RPN mode: : port_number : lib_number PURGE
Where lib_number is the library number described above.
Creating libraries
A library can be written in Assembler language, in System RPL language, or
by using a matrix-creating library such as LBMKR. The latter program is
available online (see for example, http://www.hpcalc.org). The details of
programming the calculator in Assembler language or in System RPL language
are beyond the scope of this document. The user is invited to find additional
information on the subject online.
Backup battery
A CR2032 back up battery is included in the calculator to provide power
backup to volatile memory when changing the main batteries. It is
recommended that you replace this battery every 5 years. A screen message
will indicate when this battery needs replacement. The diagram below shows
the location of the backup battery in the top compartment at the back of the
calculator.