Set-up and assembly – HONDA MM60 User Manual
Page 14
SET-UP AND ASSEMBLY
Installing Lift Rods
(For Tractors Without Rear Three Point Hitch)
1.
Adjust the
lift rod to 365 mm (14.4 in) measured
from eye to eye as illustrated. Adjustment is
made by turning barrel
of
rod, then secured by
tightening nut. Be sure that an equal length
of
threads shows on either end ,of barrel.
I
365 mm
14.4 in.
I
I
I
(with loader subframe)
I
375
mm
14.8 in.
2. Slide eye of
lift rod over pin on tractor lift arm.
Position clevis
of
lift
rod between brackets on
lift
link. Note that outside leg
of
lift
rod goes out-
side of lift link as illustrated. Install with greased
22
x 76 mm clevis pin with head on left side as
shown. Secure both ends with 22
mm washers
and linchpins.
NOTE: The eye
of
the
lift rod is not straight. The
curve should point to the inside of the tractor
when properly installed.
13