HONDA MM60 - Manual (Page 27)

INSTALLING MOWER
U-Joint Detaches From Mid-PTO
Detaching Mid-PTO and Mower Drive Shaft
1
.With engine off, PTO selector set to "REAR" and
key removed, reach under tractor and grasp the
locking collar of the U-joint of the mower drive
shaft.
2. Pull locking collar back (toward front of tractor)
to release spline of Mid-PTO. Pull the U-joint
away from the PTO, towards the mower to
remove.
NOTE:
If the locking collar is difficult to release,
turning it clockwise and counterclockwise will help
free it.
3. Make sure that U-joint is placed where it will not
be crushed by tractor tires when tractor is
backed over pulley covers.
Arm
Lift Arms Fasten to Mower Deck
Detaching Lift Joints
when pulling pins as mower deck may drop
slightly.
1. Pull pins attaching lift joints to. lift plates brack-
Keep fingers clear of brackets
ets as illustrated.
NOTE:
If hydraulic lift system is not fully down,
pins may be under tension and mower deck may
descend slightly. Make sure to keep fingers clear.
2. After detaching, temporarily replace clevis pins
in brackets and secure with cotter pins to keep
from losing or misplacing them. The
lift joints
should remain attached to the mower, not the
lift arms.
26