Maintenance – HONDA MM60 User Manual
Page 52
Advertising
MAINTENANCE
Drive Pulley Installation
1. Install drive pulley with split taper bushing on
gearbox vertical shaft. Make sure key and
keyways are aligned.
3
2.
Position centerline
of
driie pulley 0.98
&
0.030
in.
above mounting surface
of
gearbox stand as
shown. This is
a
very criiical dimension and
must be held. Alternately tighten split taper
bushing set screws to 2 kg/m
(14 ft/bs). Check
mounting distance to make sure it is correct.
1. Split taper bushing
2. Drive pulley
3.
Gearbox stand
4.
Key
Drive Pulley Assembly
51
Advertising