HONDA MM60 - Manual (Page 15)

SET-UP AND ASSEMBLY
I I
85 mm
3.4 in.
(with loader subframe)
100mm
4.0 in.
Installing Lift Rods on Lower Link Lift
(For Tractors With a Rear Three Point Hitch)
1. Replace the existing left hitch rod with the unit
provided with the mower.
2. Loosen the locknut and the adjusting nuts and
turn them to position the bracket hole 85 mm
(3.4
in) from the
lift rod eye (center-to-center
measurement). The bracket must face forward.
3. Tighten the adjusting nuts and secure with the
locknut.
4. Couple lift link chain and lift link with greased
16 mm lift pin. Head of pin faces inward. Secure
with washer and cotter pin. Attach upper end
of
lift link chain to bracket on lift rod, with greased
16 mm lift pin. Head of pin faces inward. Secure
with washer and linchpin.
14