Hard drive – HP TX1000 User Manual
Page 43
Hard drive
Description
Spare part number
5400-rpm, 160-GB
441128-001
5400-rpm, 120-GB
441127-001
5400-rpm, 80-GB
441126-001
5400-rpm, 60-GB
441125-001
Before removing the hard drive, follow these steps:
1
.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2
.
Disconnect all external devices connected to the computer.
3
.
Disconnect the power cord.
4
.
Remove the battery (see
).
Remove the hard drive:
1
.
Position the computer with the front toward you.
2
.
Loosen the two Phillips PM2.0×5.0 screws (1) that secure the hard drive cover to the computer.
3
.
Lift the left side of the hard drive cover (2) and swing it to right.
4
.
Remove the hard drive cover.
NOTE:
The hard drive cover is included in the Plastics Kit, spare part number 441138-001.
5
.
Grasp the Mylar tab (1) on the hard drive and lift the hard drive to disconnect it from the system
board.
38 Chapter 5 Removal and replacement procedures
ENWW