HP TX1000 - Manual (Page 58)

7 . Remove the WLAN module compartment cover and disconnect the wireless antenna cables from the
WLAN module (see WLAN module on page 44 ).
8 . Remove the following components:.
a . Keyboard (see Keyboard on page 47 )
b . Switch cover (see Switch cover on page 50 )
Remove the display assembly:
1 . Close the computer and turn it upside down, with the front toward you.
2 . Loosen the Phillips PM2.0×4.0 screw (1) that secures the display connector cover to the computer.
3 . Lift the rear edge of the display connector cover (2) and swing it toward you.
4 . Remove the display connector cover.
NOTE: The display connector cover is included in the Plastics Kit, spare part number
441138-001.
5 . Remove the two Phillips PM2.5×6.0 screws (3) that secure the display assembly to the computer.
6 . Remove the WWAN antenna cable (1) from the routing channel built into the base enclosure.
ENWW Component replacement procedures 53