HP 3Com Etherlink III 3C590 - Manual (Page 14)

5 Installing the 3COM Etherlink III 3C590 PCI 10BT Network Adapter
Connecting to a Windows NT 3.51 Server
8 Insert the 3COM 3C590 driver disk into the floppy drive.
9 Set the path to “A:\NDIS\WINNT35\” in the dialog-box and click on “OK”.
10 Choose by highlighting the “3Com EtherLink III PCI Bus-Master Adapter
(3C590)” and click on “OK”.
11 With “3Com EtherLink III PCI Bus-Master Adapter (3C590)” listed in the
“Network Adapters” window, click on “Next”.
12 Select the applicable network protocols and click on ”Next” (Contact your
network administrator if you do not have the required information).
13 At the “Network Services:” prompt, accept default settings and click on
“Next”.
14 Click on “Next” to continue the network card installation.
15 Set the path to “D:\I386” (D:\ represents the CD-ROM drive with the
Windows NT4 Workstation CD) in the dialog box and click on “OK”.
16 At the “Show Bindings for:” prompt, accept the default settings and click
on “Next”.
17 Click on “Next” to start the network.
18 Specify your Computer Name, Workgroup or Domain (Contact your
network administrator if you do not have the required information) and
click on “Next”.
19 Click on “Finish” to complete the installation.
20 Select “Yes” at the prompt to shut down and restart your computer for the
new settings to take effect.
21 Install the Windows NT4 Service Pack 4 application to correct the error
messages in the Event Viewer.
22 Install the Hewlett-Packard Soft-Power Down application once the
Service Pack 4 has been installed.