HP 3Com Etherlink III 3C590 - Manual (Page 7)

2 Installing the 3COM Etherlink III 3C590 PCI 10BT Network Adapter
Microsoft Windows 95 SR2.5
2 Installing the 3COM Etherlink III 3C590 PCI 10BT Network
Adapter
Microsoft Windows 95
SR2.5
Connecting to a
Windows NT 4.0 Server Requirements
• HP Vectra with Windows 95 SR2.5.
• 3COM Etherlink III 3C590 PCI 10BT network adapter and driver disk ver-
sion 5.2.2.
• Driver File: EL59X.SYS, version 1.22
• Microsoft Windows 95 SR2.5 media.
• Microsoft Windows NT 4.0 Server system that supports NetBEUI, NWLink
IPX/SPX Compatible Transport and NWLink NetBIOS network protocols.
• Device Configuration
Procedure
1 With the HP Vectra turned off, install the 3COM 3C590 network adapter
into a PCI slot.
2 Connect network cable media to the 3COM 3C590 network adapter.
3 Reboot the system to Windows 95SR2.5.
4 Windows 95SR2.5 will automatically recognize the 3COM 3C590 network
card as “3Com 3C590 EtherLink III”.
5 Insert the 3COM 3C590 driver disk in the floppy drive and click on “Next”
from the Update Device Driver Wizard dialog box.
6 When Windows 95 detects the updated driver, “3Com EtherLink III
3C590”, click on “Finish”.
7 During the Update Device Driver process, point to the appropriate file
locations (i.e. drivers disk or Windows 95 CD) to install the necessary
files. Keep newer files when a file being copied is older than the file
currently on your computer.
Device Configuration Vectra Vli8 Vectra VEi7 Vectra VEi8
Interrupt 05 03 07
I/O Address 210 210 210