HP 3Com Etherlink III 3C590 - Manual (Page 23)

9 Installing the 3COM Etherlink III 3C590 PCI 10BT Network Adapter
Microsoft Windows NT3.51 Workstation
9 Installing the 3COM Etherlink III 3C590 PCI 10BT Network
Adapter
Microsoft Windows
NT3.51 Workstation
Connecting to a
Windows NT 3.51 Server Requirements
• HP Vectra with Windows NT 3.51 Workstation.
• 3COM Etherlink III 3C590 PCI 10BT network adapter and driver disk ver-
sion 5.2.2.
• Driver File: EL59X.SYS, version 1.22
• Microsoft Windows NT 3.51 Workstation media.
• Microsoft Windows NT 3.51 Service Pack 5 media.
• Microsoft Windows NT 3.51 Server system that supports NetBEUI,
NWLink IPX/SPX Compatible Transport and NWLink NetBIOS network
protocols.
Device Configuration
Procedure
1 With the HP Vectra turned off, install the 3COM 3C590 network adapter
into a PCI slot.
2 Connect network cable media to the 3COM 3C590 network adapter.
3 Log into Windows NT with administrator privileges.
4 Open the “Network” icon in the “Control Panel” program group.
5 Click on “YES” in the “Network Settings” dialog box to install Windows NT
Networking.
6 Insert the Windows NT 3.51Workstation CD in the CD-ROM drive.
7 Set the path to “D:\I386” (D:\ represents the CD-ROM drive with the
Windows NT 3.51 CD) in the dialog-box of the Windows NT Setup window
and click on “Continue”.
Device Configuration Vectra Vli8 Vectra VEi7 Vectra VEi8
Interrupt 10 05 05
I/O Address 300 300 300