Document Outline

• 1761-UM005B-EN-P, DeviceNet Interface
• Important User Information
• Summary of Changes
• Table of Contents
• Preface
  • About This Publication
  • Who Should Use This Publication
  • Conventions
  • Additional Resources
• Chapter 1
• Overview
  • Introduction
  • Operating Modes
  • Device Compatibility
• Quick Start
  • Configure Peer-to-peer Messaging
  • Configuring Master/Slave I/O
• Chapter 3
• Operation
  • Modes of Use
  • DeviceNet I/O
    • Input Image
    • Output Image
  • Network Configuration Software
  • Messaging Services
    • I/O Assembly Messaging
    • Programmable Controller Communications Commands (PCCC) DeviceNet Messaging/ DF1 (peer-to-peer)
  • Programming Over the DeviceNet Network
    • Local Access to a DeviceNet Network
    • Remote Access to DeviceNet (Modems)
• Chapter 4
• Installation and Wiring
  • European Communities (EC) Directive Compliance
    • EMC Directive
    • Low Voltage Directive
  • Safety Considerations
  • Mounting
    • DIN Rail Mounting
    • Panel Mounting
  • Network Port Wiring
    • DeviceNet Network
  • Cable Selection Guide
• Chapter 5
• DNI Configuration Parameters and Programming Notes
  • Information About DNI Series B
  • EDS Parameters for the DNI
    • Input Size
    • Input Split Point
    • Input Type
    • Input Data File
    • Input Word Offset
    • Output Size
    • Output Split Point
    • Output Type
    • Output Data File
    • Output Word Offset
    • Device Type
    • I/O Scan Enable
    • DF1 Heartbeat
    • Data Scan Delay
    • Message Timeout
    • DF1 Substitute Address
    • DF1 Autobaud
    • DF1 Baud Rate
    • DeviceNet Autobaud
    • DNI Mode
  • Programming Notes
    • Input Messaging
    • Input Messaging Considerations
    • Status Byte
    • Input Status to Master Device
    • Output Status to DF1 Device
• Chapter 6
• Setup, Programming, and Troubleshooting
  • DNI Software Files
    • DNI Series A Information
    • DNI Series B Information
    • File Descriptions
    • Obtaining the Files
  • Setting Up Network Configuration Software
    • Setting Up DNI Configuration Software Utility
    • Setting Up RSNetworx
    • Setting Up DeviceNet Manager
  • Commissioning the DNI
  • Programming Over the DeviceNet Network
    • Computer with DNI
    • Computer on DeviceNet Network
  • Modifying DNI Parameters
    • Use the main configuration to set or change any of the DNI parameters. Disable Polling Enable while you are making changes. When you are finishing, click Save to File and Save to DNI.
    • Using RSNetWorx to Modify Parameters
    • Using DeviceNet Manager to Modify Parameters
  • Troubleshooting
    • Module Status LED (MOD LED)
    • Network Status LED (NET LED)
    • RS-232 Port LED Indicator
  • Fault Conditions
  • DNI Series A DeviceNet Class Codes
    • Identity Object
    • Slave I/O Assembly Data
  • DNI Series B DeviceNet Class Codes
    • Identity Object
    • Input Assembly Data (Explicit, Split Point, and Slave)
    • Output Assembly Data (Explicit, Split Point, and Slave)
• Chapter 7
• Application Examples
  • MicroLogix as I/O on the DeviceNet Network
  • Example DNI Configuration Parameters
  • Example Ladder Logic
    • DNI - MicroLogix Heartbeat Logic
    • DNI - COS (change of state) I/O Messaging
• Chapter 8
• Explicit Messaging (DNI Series B Only)
  • Using DF1 Protocol for Explicit Messages Over a DeviceNet Network
  • Routing Profile Configuration
  • Explicit Messaging Examples
    • Reading (Get) Data Example
    • Writing (Set) Data Example
• Appendix A
• Specifications
  • Physical Specifications
  • DeviceNet Specifications
  • Dimensions
    • Mounting Template
• Glossary
  • Interface Basics
  • Terms and Abbreviations
• Index
  • Numerics
  • A
  • B
  • C
  • D
  • E
  • F
  • G
  • H
  • I
  • L
  • M
  • O
  • P
  • R
  • S
  • T
  • U
• Back Cover