Rockwell Automation 1761-NET-DNI DeviceNet Interface (DNI) - Manual (Page 62)

Publication 1761-UM005B-EN-P - October 2006
62 Setup, Programming, and Troubleshooting
Using DeviceNet Manager to Modify Parameters
Once a DNI is placed on the network, double-click to open the EDS
file. All adjustable parameters that configure the DNI for operation are
set up through this configuration utility. The illustration below shows
the DeviceNet Manager Device Configuration screen with each DNI
configurable parameter.
To configure any of the parameters, perform this procedure.
1. Highlight the parameter.
2. Click the Modify Parameter button, or double-click on the
parameter.
3. For DNI Series A, set DNI mode to Standby. For DNI Series B,
set I/O Scan Enable to Disable.
4. Change the parameter data as needed.
5. For DNI Series A, set DNI mode to Operational. For DNI Series
B, set I/O Scan Enable to Enable.
6. For more detailed information, click on Help.
Once a parameter is changed or after all parameters are
changed, click Save to Device.