Document Outline

• HMM100 USER'S GUIDE
  • TABLE OF CONTENTS
  • GENERAL INFORMATION
    • About This Manual
      • Contents of This Manual
      • Version Information
      • Related Manuals
      • Documentation Conventions
    • Safety
      • ESD Protection
    • Recycling
    • Regulatory Compliances
    • Patent Notice
    • Trademarks
    • License Agreement
    • Warranty
  • PRODUCT OVERVIEW
    • Introduction to HMM100 Series Humidity Modules
    • Basic Features and Options
    • Probe Types
    • Filter Types
      • Catalytic VHP Filter
    • Installation Accessories
      • Probe Mounting Flange
      • Mounting Bracket with Lid
      • Module Housing (IP65)
      • Probe Mounting Clamp
  • INSTALLATION
    • Dimensions
    • Installing the Module
    • Installing the Probe
    • Wiring
      • 2-wire Output
      • 3-wire Output
    • Verifying the Installation
  • OPERATION
    • Using the Service Port
      • Installing the Driver for the USB Cable
      • Terminal Application Settings
    • List of Serial Commands
    • Device Information and Status
      • Show Device Information
      • Show Quantities
      • Show Calibration Info
      • Show Analog Output Status
      • Show Firmware Version
    • Serial Line Output Commands
      • Start Measurement Output
      • Stop Measurement Output
      • Set Output Interval
      • Output a Reading Once
    • Calibration Commands
      • Calibrate Temperature Measurement
      • Calibrate Humidity Measurement
      • View User Adjustment Parameters
      • Set User Adjustment Parameters
      • Zero the Trimmers
      • Calibrate Analog Output
    • Configuring Serial Line Operation
      • Set Serial Line Settings
      • Set Terminal Echo
      • Set Module Address
      • Set Serial Interface Mode
    • Configuring Measurement Parameters
      • Set Environmental Compensation Values
      • Set Temporary Pressure Compensation Value
    • Configuring Analog Output
      • Set Analog Output Mode
      • Select Analog Output Quantity and Scaling
      • Test the Analog Output
    • Other Commands
      • Display Command List
      • Enable Advanced Commands
      • Display the Currently Active Errors
      • Connecting to the Module in POLL Mode
      • Closing the Connection in POLL Mode
      • Save Changed Settings
      • Restore Saved Settings
      • Reset the Module
      • Restore Factory Settings
  • MAINTENANCE
    • Changing the Filter
    • Changing the Sensor
    • Calibration
    • Calibration and Adjustment Using Trimmers
    • Calibration and Adjustment Using Serial Line
      • Temperature Calibration (CT)
      • Humidity Calibration (CRH)
  • TROUBLESHOOTING
    • Analog Output Error Notification
    • Solving Typical Problems
    • Technical Support
    • Product Returns
  • TECHNICAL DATA
    • Specifications
      • Performance
        • Relative Humidity
        • Dewpoint Temperature
      • Operating Environment
      • Inputs and Outputs
      • Mechanics
    • Options and Accessories